銀離子整理劑SilverClear

SilverClear 是以銀離子為主要成分的溶液,目前已被美國環保署(US EPA )認證(注冊號;84630-2) ,作用原理為分子釋放兩種類型的離子,陽性分子可以迅速撕裂的保護壁,較小的銀離子隨后進入破壞的外膜,擾亂的呼吸系統及破壞的DNA ,經AATCC 100的檢測,在經過多達100次洗滌之后,仍具有優異的、效果?？蓮V泛應用于棉、滌綸、尼龍、晴綸等織物。

一、物化性能

外觀:乳白色液體

離子型:陽離子

pH: 2.5-4.0

溶解性:易溶于水

兼容性:與樹脂,粘合劑,氟碳防水劑及其它整理助劑有很好的相容性。

二、使用方法

可參照下面順序試驗后使用:

1.浸軋及涂層 采用浸軋工藝使用SilverClear , 軋余率在30% - 60%左右。為了獲得更好的效果,建議SilverClear 在后-槽中加入(烘干前)。用量2%-5% ,如加大該產品用量,效能及耐洗滌能力也會顯蓍提高

2.噴涂法 SilverClear 可以用稀釋液(20%及以上)或原液進行噴涂應用。由于該產品不含任何有害溶劑,所以在準備SiIverClear 工作液或應用時，不需要專門的通風，排氣裝置。當然 ,必須遵守當?shù)氐穆殬I(yè)健康要求規定。為了獲得更好的性能, SilverClear 應在后一步整理中使用。

3.烘干及烘培 為了獲得更好的耐洗性能 ,處理后的織物需要在120℃烘干，然后在170℃ -180℃烘培20秒以上

產品性能

1.有效殺滅、、霉菌,從而讓紡織品保持清新無異味。

2.不影響產品手感及光澤

3.使用簡單，能與其他產品一起應用，無需額外加工工藝

4.適用于纖維、紗線紡織面料、紙張過濾材料、機織物、無紡布。

5.已在美國環保署注冊認證

貯 存

1.使用前請攪拌均勻。通過較劇烈的攪拌 或攬拌(渦旋)確保容器底部沒有任何沉淀物?？梢允褂脦в?3葉螺旋槳的電動攪拌器以獲得良好攪拌效果。盡量避免產生過多泡沫。SilverClear溶液應儲存在桶中 ，放置于陰涼干燥的環境里,并避免強紫外線照射。

2.禁止暴曬以及放置在高溫環境下。

溫馨提示：本網站所展示單價均為200g 小樣運費，各產品實際單價待確認要求后報價。

Silver Ion Antibaterial Finishing Agent SilverClear

SilverClear is an antibacterial solution with silver ion as the main component. It has been certified by US EPA (Registration Number: 84630-2) at present. The working principle is as follows: Molecules release two types of ions. Positive molecules can tear the protective wall of bacteria rapidly. The smaller silver ions then enter and destroy the outer membrane of bacteria to destroy the respiratory system and DNA of bacteria, After AATCC 100 detection, more than 99.9% of the bacteria can be eliminated quickly. After up to 100 times of washing, it still has excellent anti-bacteria and sterilization effect. It can be widely used in cotton, polyester, nylon, acrylic and other fabrics.

Physical & chemical properties:

Appearance: Milky white liquid

Ionicity: Cationic

pH: 2.5-4.0

Solubility: Soluble in water

Compatibility: Good compatibility with resins, adhesives, fluorocarbon water proofing agents and other finishing agents.

Usage:

It can be used after the following sequence of tests:

1. SilverClear is used for padding and coating, with a liquid rate of 30% - 60%. For the better antibacterial effect, SilverClear is recommended to be added in the last bath (before drying). The dosage is 2% - 5%. If the dosage of the product is increased, the antibacterial effect and washing resistance will also be improved.

2. Spray method. SilverClear can be applied as a diluted solution (20% or more) or original solution. Since the product does not contain any harmful solvents, there is no need for special ventilation device when preparing SilverClear working solution or during usage. Of course, local occupational health requirements must be observed. In order to obtain the better antibacterial performance, SilverClear should be used in the final finishing step.

3. Drying and baking in order to obtain the better washing resistance, the treated fabric needs to be dried at 120℃ and then baked at 170℃-180℃ for more than 20 seconds.

Characteristics:

1. Effectively kills bacteria, fungi and molds, so as to keep textiles fresh and odorless.

2. Does not affect the hand feel and luster of the product.

3. It is easy to use and can be used with other products without additional processing technology.

4. Suitable for fiber, yarn knitted/woven fabrics, paper filter materials, woven fabrics, non-woven fabrics.

5.Registered and certified by EPA.

Storage:

1. Stir evenly before use. Make sure that there is no sediment at the bottom of the container by more vigorous stirring or stirring (vortex). An electric stirrer with a 3-Blade propeller can be used for better mixing. Try to avoid creating too many bubbles. SilverClear solution should